Objective :
- · To testing the circuit in Breadboard
- · To make sure the circuit functioning well
Content/Procedure :
- · Both of the circuit have to been testing on breadboard before solder it into itching board.
o
Circuit Type :
Transmitter & Receiver
o
Braedboard :
2
o
Baterry use :
9V=2 , 1.5V=2
o
Jumper :
4 colour
Result/Analysis :
- For this week, I need to attach the component on Breadboard and test the circuit functionality based on the drawing circuit I have made before. I will test the connectivity between the transmitter and receiver and the range it could reach. The component have been attach on the breadboard like the picture shown below. I have make a test of the connectivity between the transmitter and receiver and I have to make sure the circuit functioning well.
Transmitter :
o
Functioning well
Receiver :
o
Functioning well
Conclusion :
For the conclusion on this week, I have
successfully done the objective for this week. I have done doing my circuit on
the breadboard and test the functionally of the circuit.
No comments:
Post a Comment