Objective :
- · To Itching and solder alarm circuit
- · To attach alarm circuit into receiver circuit
- · To test GSM GPS System functionality
Content/Procedure :
- · Itching and solder the alarm circuit into the itching board. Then testing the alarm circuit functions and makes it connected together with receiver circuit. After that, the GSM GPS System have been test and been configured. The details are shown below:
o
GSM GPS Test : Using laptop to registered and configured
the places.
o
Date : 2nd April 2014
o
Software used : GPS Tracker Version 2.0.0.0
o
Accuracy : 95% accurate based on internet
and GPS
o
Delay time : Less than 30 seconds the message
arrived
o
Maps type : Google maps
Result/Analysis :
- For this week, I need to make the alarm circuit and connected it together with the receiver circuit. The function of the alarm circuit is to warning this device user and makes them alert if the transmitter is far away from them. Other than that, I also test the GSM GPS Tracker System that has been used in my project. The function of this GSM GPS System is to track the transmitter location within a second. It can help to prevent the transmitter user from being missing. There is some software use to configure the GSM GPS Tracker Device to specify the user country. The GSM GPS Tracker device function is when the user makes a call to the Tracker device, the device will automatically responding and gives a message to the user smart phone less than 30 second. So the user can automatically track the device current location at that time. The picture of the device is shown below:
Conclusion :
- For the conclusion on this week, I have successfully done the objective for this week. I have done soldering the alarm circuit and connected it together with the receiver circuit. I am also have done configuring and testing the GSM GPS Tracker device to been used on my project. The purpose of this project is to prevent the transmitter device from being missing.
No comments:
Post a Comment