WEEK 14 FYP

Objectives   : Completion of FYP 1
Activities     : No
Analysis      : Shown below

By completing the proposal and this blog, My FYP Sem 1 for this semster have complete and will be continued on My Fyp Sem 2 next Semster. That's all For this Semester, Thank you.

TO BE CONTINUED ......

WEEK 13 FYP

Objectives   : To submit proposal
Activities     : This week is a deadline for submission proposal report. I have to updates my proposal and and compile it before submit to my supervisor. I have to double check the needed and requirement to be put in proposal report.
Analysis      : The details shown below is the requirement needed in Proposal report:

REQUIREMENT NEEDED:

• Title Page
• Abstract
• Table of Contents
• Introduction
• Problem Statements
• Literature Review
• Methodology
• Objective
• Benefits / Contributions
• Work Plan
• Budget
• Conclusion
• References

UniKL BMI Proposal Guidelines

My Proposal Content

WEEK 12 FYP

Objectives   : To understand about the project block diagram

Activities     : For this week, i have to update my block diagram that shows how the device work. The Block diagram is important because it will shows how my device will work and it will show the percentage of possibilities of the device will working. I also have to update my gantt chart for the entire semester that i am doing for FYP 1.

Analysis      : The detials are shown below:

RF TRANSMITTER AND RECEIVER BLOCK DIAGRAM:

RF Transmitter :

Referring to the Figure above, the block diagram is representing how the RF transmitter block diagram functioned. When the power supply gave a power to the RF transmitter, the input will transmit to the oscillator using a key, go through to the antenna. This input, that a signal which will transmit to the receiver to send a signal  to the receiver circuit.

RF Receiver :

Referring to the Figure above, the block diagram representing how RF receiver block diagram is function. When the signal came from antenna, the transmitter will transmit that signal. That signal will cross the coil, and sent that signal to pre amplifier. After pre amplifier, the filtering process produces to decrease the noise of signal. From that, the output, that signals will out in the open and will sent to the owner of the receiver circuit. It will also use the power supply to operate the circuit.

Gantt Chart: